CA-48 brand instant glue 3M Packing 28.3 g / support material type ethyl temperature range -40 ℉ ~ 200 ℉ (-40 ~ 93 ℃) Product features rapid bonding, proper bonding strength, curing time and viscosity terms of strength, curing time and viscosity to fully meet your requirements for processing time and performance. These one-component cyanoacrylate adhesives without catalyst to quickly reach operating strength at room temperature. In many applications, the adhesive strength of the operation can be achieved within 5-10 seconds, in 1 hour to reach 80% of full strength. A drop per square inch to spend, you can bond a variety of plastics, rubber, metal and other materials. Tensile strength of up to 5000psi. Resistant to fuel oil, lubricants and other chemicals. High peel strength and impact strength; compliance with MIL-Speca-46050C of. Usage bonding of various metals, plastics, rubber and other materials. Gently squeeze to use plastic bottles, the glue evenly coated adhesive material being above (surface to be bonded must be clean, dry and free of grease), After coating, the adhesive material on the other side is immediately fit in surface coating can be. About 10 seconds can be bonded, until the glue to cure for 24 hours to reach maximum strength. Shelf life 12 months Note glue so as not painted too much, too much influence of the glue curing time, in addition, the relative humidity is too low is an important reason for not fully cured glue, the glue is both moisture curing conditions, also whitened the reason. Therefore, the following points should be noted: 1. To ensure that the working environment ventilated 2. Not fully cured before, not sealed packaging 3. control dispensing volume, precision dispensing 4. Use the accelerator to accelerate the curing glue